Fcoe driver linux

FCoE Driver Tuning for VMware® ESXi, Linux®, and Windows® bnx2fc_queue_depth (Per-LUN Queue Depth) The bnx2fc_queue_depth (per-LUN queue depth) command adjusts the per-LUN queue depth for each adapter. Setting the queue depth to 0 indicates that the driver should use the system default. Setting the queue. Broadcom FCoE offload through bnx2fc is full stateful hardware offload that cooperates with all interfaces provided by the Linux ecosystem for FC/FCoE and SCSI controllers. As such, FCoE functionality, once enabled is largely transparent. standard local disk boot configurations, although the FC/FCoE driver will load upon system boot, the target storage LUNs will not be discovered. Note: You can use the Linux “lspci” utility to determine whether an adapter is LPexB or LPex, and therefore whether it is supported by the RHEL

The binary RPM FC and FCoE driver kit contains the following: A zipped tar file that includes the driver binary RPMs for a specific driver version and Linux distribution NOTE Use only officially-released Linux distribution kernels. The theory behind FCoE is extensive, so before we start the configuration process, I'll give the simplest overview related to concepts, and definitions, that might help you to understand the commands used to set up FCoE on Red Hat Enterprise Linux. Disclosure: there is much more to this technology than what's written here. (FCoE), Ethernet, and internet Small Computer System Interface (iSCSI) drivers that are applicable in this manual. A check mark “ ” indicates the type of driver distribution that is supported.

bfa driver supports all Brocade FC/FCOE adapters. Below is a list of adapter models with corresponding PCIIDs. Feb $fnic: Cisco FCoE HBA Driver, ver [root@linux-host]# dmesg | grep -i enic. You can also run cat /sys/module/enic/version for eNIC. Verify that you can ping another device on the network using this Ethernet interface before attempting to setup FCoE. 5. The driver for the Broadcom network.